Elinchrom RX 1200 Instruções de Operação

Englishelinca sa switzerland www.elinchrom.comElinca S.A Digital RX 01.06.2007 ENG (73256) Printed in SwitzerlandOperating ManualVersion 230 V - 102

9FlashheadsWhen plugging in a lamphead connector, rst push in the front part, then rmly press in the whole plug, the rear part being secured by the

10Flashhead CompatibiltyBelow is a table, listing lampheads made since 1980, which are adaptable and indicating the equivalent in the current series.C

Technical DataUnits Digital 1200 RX Digital 2400 RX f-stop variation 22 to 128 f-stop variation 32 to 180Charge Speed (mains 230V/60Hz)normal 0.3 - 1

The charge socket is as well the interface for the EL-Skyport Trigger and Remote System.With the EL-Skyport RX Trigger Set 19362, the Digital RX can b

13Elinchrom Accessories codeReectors Wide angle ø 16 cm /90° 26143Compact ø 18 cm /60° 26144Standard ø 21 cm

14This ELINCHROM product will be repaired free of charge by the vending agent if during a period of 24 months from date of purchase its working order

www.elinchrom.com

1P.S: Technical data subject to change.The listed values are guide values which may vary due to tolerances in components used.Introduction 2Declaratio

2 The quality of light and exceptional performance is the result of long research, application of demanding principles, the long experience of E

3CE marking The shipped version of this device complies with the requirements of ECC directives 89/336/ECC «Electromagnetic co

4• Keep ash units out of reach whenever possible.• Switch off when not in use and disconnect ashheads.• Do not use in restricted areas (like hospita

5Overview of Controls 1. Mains inlet socket 2. Fuse AC supply (16 AT, slow blow) 3. Illuminated mains switch 4. Modelling control (on/off free

6Operating Instructions The power control provides simultaneous and continuously variable adjustment of the modelling lamp and the ash p

7Charge Ready Beep (9)Press this touch (9) to activate the acoustic signalOnce recycled, an acoustic signal (beep) indicates that the power pack is re

8This unit is protected by security device.Should the unit not work properly, due to a defective power component,the security would instantly stop the