Elinchrom RX 1200 Instruções de Operação descarregar pdf (Página 7)

Operating Instructions

The power control provides simultaneous and continuously variable adjustment

of the modelling lamp and the ash power in step of 1/10 f-stop.

The display, provides digital power information, in f-stop from 3.5 to 8.5 for the

"Digital 2400 RX" and 2.5 to 7.5 for the "Digital 1200 RX".

Digital Power Regulation (12 and 13)

The actual ash power is displayed in a f-stop compatible format.

The power range is 6 f-stops. The digital display, provides continuous power

indication of the ash and modelling lamp. The controls cover a continuous

output range from full power 1/1 to 1/32th in 1/10th f-stop steps.

During charging or discharging the display "ashes". In case of overheating

or malfunction, the display shows "ER" for error.

Digital Power Display (14)

On/Off Switch (3)

By pressing this touch button the Digital RX is switched on or off.

This unit is protected by a thermal circuit breaker to avoid overheating. Should this

occur, the unit turns off automatically and cannot be operated! After a break for cooling,

the ash is ready again for operation.

Modelling Lamp Controls (4-16-17)

• Proportional: The modelling lamp will be adjusted automatically in proportion,

when the ash power is set to another value with touch button 12 or 13.

• Free: To set ash- and modelling lamp values individually.

• Modelling Lamp off

Note: There is an additional ON/OFF switch for the modelling lamp at the ashhead!

The ashhead control button A/B must be switched on for the selected ashhead.

Before connecting the digital RX for the rst time, make sure that your mains supply and the rating

set on the equipment (electrical specication plate) are compatible to 110V or 230V.

• Connect lampheads ensuring that lamphead touches (18-19) are Off.

• Connect the mains cord in the inlet socket (1)

• Select charging rate (11) (" " slow position), only when the mains supply is too limited.

• Select modelling lamp setting (4)

• Connect the synchro lead (10)

• Check that the photocell’s switch (6) is in the required position.

• Use the touch buttons (12 - 13) to select the desired power.

• The open ash (5) will light up, indicating that the unit is ready for operation.

Fonctions

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Sem comentários

Elinchrom RX 1200 Instruções de Operação Página 7